Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-27-2002, 08:54 PM
|
#5 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
ok go back and read the last few lines of what i wrote above.... it states:
so w/ pedestal mount substitute "slowly torque to 20 pounds" everywhere I wrote "tighten them down 3/4 of a turn". BTW, if it takes more than one full turn to reach 20 pounds after zero lash, you will need to install shims.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Advice on injectors...PKRWUD I'd like your advice on this one as well | silver_pilate | Windsor Power | 3 | 06-09-2003 08:59 AM |
| crane 1.7's installed, now need help on valve covers | Coupe50h | Windsor Power | 6 | 11-14-2002 09:12 PM |
| Really, really love my crane 1.7's | Coupe50h | Windsor Power | 6 | 11-14-2002 04:26 PM |
| Crane 2031 cam and Edelbrock intakes on, impressions..... | 93CobraR | Windsor Power | 4 | 05-23-2001 11:53 AM |
| puttin heads on tomorrow, any advice? | fiveohpatrol | Windsor Power | 7 | 04-28-2001 10:59 PM |