Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-29-2002, 10:58 AM
|
#9 |
|
Registered Member
Join Date: Jul 2002
Location: Flemington, NJ
Posts: 13
|
like everyone else, I didn't really notice any horsepower increase. One thing I did not like about the kit was there were 3 bolts holding the tube from the mass air meter to the bracket that mounts to the fenderwell, unlike everyone elses where that part is welded. One of the nuts on the other side of the bracket was hitting the edge of the cut out in the fenderwell so I had to get my grinder and make a small notch. I bought a 75mm Pro-M Bullet mass air meter later on and found out that it was too long and I had to cut about an inch off the tube that goes from the meter to the TB. That's just my experience with them, it's possible that maybe I got an older revision kit or something, but I think I'm going to stick with BBK from now on.
__________________
'91 GT - 135K miles T-5, stock 2.73's uugh, MAC cold air, Pro-M Bullet 75mm, BBK 1 5/8 jet-hot unequal shorties, BBK h-pipe w/ cats, Flowmaster 2 chambers, Pro 5.0 short throw, KYB shocks and struts In the garage waiting to be put on: Screamin Demon coil, Dyna Mod TFI module, underdrive pulleys Last edited by 1991GT; 10-29-2002 at 11:33 AM.. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can water get in your engine through a cold air intake? | NYC1 | Windsor Power | 10 | 04-20-2005 08:39 AM |
| Trick Flow intake problems | shacar87 | Windsor Power | 9 | 11-14-2003 05:53 PM |
| Cobra Intake? | 95mustanggt | Windsor Power | 5 | 10-01-2002 09:55 AM |
| OIL IN INTAKE almost sure from 'pcv' | QUIN | Windsor Power | 8 | 03-09-2001 01:58 PM |
| Cold Air Intake Discussion | King Snake | Modular Madness | 7 | 10-13-2000 04:37 PM |