Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
10-31-2002, 09:31 PM
|
#1 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
ok, so you don't have to drill for the act sensor, but do you still have to drill for the egr water lines or is there a way around that? you said you didn't drill anything so I assume theres a way around it or your not running water to the egr anymore right?
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cobra Intake? | 95mustanggt | Windsor Power | 5 | 10-01-2002 09:55 AM |
| Installing Explorer Intake | MattwantsSpeed | Windsor Power | 16 | 09-01-2002 10:56 AM |
| I am new, and I dont know why Explorer Intake manifolds are so swell? | ChesteR | Windsor Power | 4 | 09-29-2001 02:29 AM |
| explorer intake | myred86gt | Windsor Power | 4 | 09-26-2001 12:18 AM |
| need advise on explorer intake | joey50gt | Windsor Power | 3 | 04-21-2001 07:22 AM |