Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
11-01-2002, 01:19 PM
|
#1 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
I don't know... for just the subframes and installation that sounds al ittle high to me. the actual frames are under 100 dollars new and for a couple of easy welds under the car shouldn't cost more than 50 dollars.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What conveter for a good price? | Silver5.0 | Windsor Power | 3 | 10-12-2001 10:00 AM |
| Where can I find some Iron GT40's at a good price | 95 King GT | Windsor Power | 3 | 09-18-2001 12:36 AM |
| Wheels/Tires for sale. What's a good price | Mike Souslin | Blue Oval Lounge | 6 | 06-28-2001 10:51 PM |
| WHAT'S A GOOD PRICE FOR A CAGE INSTALL? | dirtyGT | Blue Oval Lounge | 2 | 03-26-2001 01:30 PM |
| What a good price for a used Lakewood Scatter shield? | TRAXX | Windsor Power | 3 | 02-14-2001 01:33 PM |