Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
11-03-2002, 07:59 AM
|
#1 |
|
Registered Member
Join Date: Sep 1998
Location: Oviedo, FL
Posts: 992
|
With the compression the way it is you can rule out a burnt valve. Try the WD-40 stuff for an external vacumn leak. But, it can leak on inside too.
I'd just pull the intake, it's not that hard, and eyeball those gaskets good. Then before you reinstall dry fit the intake and check the gasket fit. Incase the heads have been milled excessive, etc. Buy, GOOD gaskets and leave the end gaskets out. Use RTV. When done properly it is a MUCH better seal and allows the manifold to settle into place easier.
__________________
"Support our Troops" Dave 1968 Cougar 2004 Thunderbird 2007 F150 Harley-Davidson, SuperCrew 1986 LTD 1997 Ranger 1992 Honda Civic |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Surges at Partial Throttle | Comatose | Windsor Power | 12 | 05-02-2004 05:14 PM |
| Surging at higher speeds and RPM | Rosco | Windsor Power | 5 | 10-12-2003 11:08 PM |
| Car surges voilently and looses power in first? | jpumpkinn | Windsor Power | 3 | 07-31-2001 02:16 PM |
| Slight popping and Bucking at low speeds. | 87GTman | Windsor Power | 0 | 03-27-2001 01:47 AM |
| Shaking at freeway speeds | SirenSong | Classic Mustangs | 7 | 03-02-2001 08:04 PM |