Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
11-10-2002, 01:44 PM
|
#1 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
The EGR passage is external on the holley. It enters the upper intake "from the underside of the throttlebody by the linkage." You may have a bad egr valve or the spacer was installed inpoperly. Also, make sure the egr tube is installed correctly and all your gaskets were installed facing the right way. If the EGR spacer gasket was installed wrong, (gasket surface not clean enough, installed backward) The coolant passing through it will leak out into the intake along with some EGR crap making a milkshake type substance. Pull the intake tube off and open the TB and take a peek inside.
It seems like the EGR spacer was installed improperly, mainly the gaskets. Check 'em out.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trick Flow intake problems | shacar87 | Windsor Power | 9 | 11-14-2003 05:53 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| which gaskets to run with Holley intake edelbrock heads | NewAge 5.0 | Windsor Power | 3 | 01-26-2002 04:38 PM |
| Cobra lower intake install??? | stalkernotch | Windsor Power | 1 | 07-31-2001 05:03 PM |
| new coolant leak after intake install | fiveohpatrol | Windsor Power | 15 | 03-04-2001 09:15 PM |