Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-14-2002, 04:23 PM
|
#4 |
|
Mustang Addict
Join Date: Jan 2001
Location: McKinney, TX
Posts: 1,294
|
If the bend in them isn't exactly right so that they butt up flush against your unibody rails, you may have to heat and bend them a little to get them to fit right. I had to do this with the subframes I put on my '79 and it really wasn't a big deal. The only other issue I would see is if they have the cross pieces that support the floor where the seats bolt in. The floor on some of my Foxes tore there before, so I think they are a good feature.
__________________
Strike down the unroadworthy! 2000 GT Atl. Blue: '03 Cobra motor - 465rwhp/473rwtq, T-56 6-speed, full MM TA/PH & tubular K-member suspension, Saleen body, 17" Torq-Thrust II's, M/T ET Street radials, and lots more '94 Rio Red Cobra: All the bolt-ons, 3.73s |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cheap ways to drop ET? | Nixon1 | Windsor Power | 23 | 12-20-2003 01:36 PM |
| CoastHP 347-GT stroker CHEAP??? | 5ohCOUPE | Windsor Power | 1 | 03-09-2003 09:58 PM |
| Cheap Cheap Porting Would it work? | vetteeatr | Blue Oval Lounge | 1 | 11-02-2002 10:34 AM |
| Cheap Parts dont Pay in the long Run!!! | Stang Runner | Windsor Power | 5 | 05-07-2002 10:24 PM |
| 306 or 308 intake (cheap) | QuantumMotorsports | Windsor Power | 1 | 05-18-2001 06:45 PM |