Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-24-2002, 05:33 PM
|
#10 |
|
Registered Member
Join Date: Jul 2001
Location: West Bloomfield, MI
Posts: 391
|
all BBK flange welds are pretty bad, all you had to do was cut out the imperfections with a carbide bit... takes 2 seconds so i dont think it was worth sending them back because chances are you will get back the same quality....
i also opened the collector flange on my BBK longtubes because they were only 2 1/4" and i opened them up to about 2 3/4". i think for the money BBK's are pretty hard to beat. MAC is terrible, dont go that route. take care, adam
__________________
90 GT black/ grey leather ported GT-40 heads w/ 1.7RR, Cobra intake w/ ported lower, 24# injectors, 190LPH pump, 75mm Pro-M MAF, 65mm TB, K&N panel, BBK long tubes, Off road H-pipe, 2 ch. Flowmaster, Black magic fan, Kirban FPR, 180 deg. T-stat, 3.73's, Steeda Tri-Ax, 130 amp alt. Accell 8.8 race wires/cap/rotor, motorcraft plugs, Factory Five suspension, etc etc etc.... http://avbcon12.stangnet.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SVO Shorty Headers 1-5/8 Question | stangposse | Windsor Power | 0 | 08-07-2003 12:48 PM |
| Buying new headers | TwiLighTBluEGT | Windsor Power | 4 | 04-23-2003 08:55 PM |
| Anyone have problems with MAC headers?? | HiFlow5 0 | Windsor Power | 15 | 05-30-2002 08:30 AM |
| Headers should I or shouldn't I....Need Advice Quick Please | Mustang_GT_90 | Windsor Power | 9 | 05-01-2002 01:16 PM |
| BBK one-piece flange or MAC individual flange long tube headers. | Fox Body | Windsor Power | 10 | 04-03-2001 04:25 PM |