Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
06-28-2001, 04:46 PM
|
#1 |
|
Registered Member
Join Date: Jan 1999
Posts: 126
|
Try to get money for an intake tb and maf our combos are very similar and I run 12.80 you would make dust out of him
------------------ 93 coupe,373's ripper shifter,MAC 1-5/8 equal lengths,MAC 2-1/2" H-pipe with cats,flowmaster 2 chambers,lowered 1-1/2" with BBK springs.Motorsport HD clutch,,FMS pullies,75mm bullet maf,walbro 190 lph fuel pump,kirban adj fpr.edelbrock 6037's e303, cobra intake frpp 1.6 roller rockers mac cold air kit msd 6al 3" cowl hood factory five upper and lower control arms wms subframe connecter and strut tower brace 12.81@ 105.1 1.66 60ft |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Proper pushrod length? | Nixon1 | Windsor Power | 3 | 02-05-2004 02:36 PM |
| Speed secret # 5 | jim_howard_pdx | Windsor Power | 37 | 11-15-2002 12:19 PM |
| Subframe connectors, full length vs. standard | flyin 5.8 | Windsor Power | 2 | 10-01-2002 09:41 AM |
| Full length or shorties? | Nicodemus | Small Ponies | 5 | 08-04-2002 10:55 AM |
| full length or standard length subframe connectors? | 84stangLX | Windsor Power | 4 | 04-23-2001 03:48 PM |