Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
12-02-2002, 12:46 AM
|
#1 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
I'm sure you can get a 351 to pass inspection. There are cars otu there that came with 351's stock and easily pass inspection so i don't see why it would be a problem to get an aftermarket to pass. As for a stroker on a 351 block... no idea.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 351W Heads on a 87 302 Block | NitroNixon | Windsor Power | 5 | 05-08-2003 09:29 PM |
| 351W heads on 289 stock engine | sleeperstang | Classic Mustangs | 5 | 11-21-2002 08:35 PM |
| Where to find 351W SVO | GodStang | Windsor Power | 0 | 10-11-2002 02:04 PM |
| 351W in a Fox body | greydan | Windsor Power | 4 | 07-03-2002 02:33 PM |
| HP #'s from a built 351W versus FMS 351 versus stroker | stroker393 | Windsor Power | 0 | 03-09-2001 10:24 AM |