Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-07-2002, 03:52 PM
|
#2 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
I'm not sure if i got the question complete right about the rear springs, but when you take the lower control arms off to switch out, the springs basically fall out of the car. So yeah you can change them with hand tools and a driveway. I put lakewood lower control arms on with a floor jack, two breaker bars and a good socket set. Just make sure the car is held off the ground by the frame and not the rear axle/suspension cuz if its held up by teh suspension there will be all sorts of compression in your springs and they're gonna fly outta there when you unbolt the lower control arms.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 40 reasons FOR gun control | DAN-MAN | Blue Oval Lounge | 22 | 11-13-2002 05:19 PM |
| granatelli lower control arms are junk! | sn95gt19 | Windsor Power | 9 | 07-02-2002 09:37 AM |
| How to install lower control arms? | Coupe5oh | Windsor Power | 6 | 05-20-2002 02:34 PM |
| Groupounder lower control arm install | leo | Windsor Power | 3 | 04-13-2001 06:13 AM |