Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
12-08-2002, 01:56 AM
|
#1 |
|
Registered Member
Join Date: Aug 2001
Location: Ft. Worth, TX
Posts: 456
|
Silicone
I tried what you said with the Ultra black, but it was not even close to sealing it. The bead was super thick as well. It just isn't going to seal without jerry rigging. I don't know if it was manufactured improperly or what. I will just put the stock one back on and get the Edelbrock check out after measuring the gap. Thanks everyone.
P.S. That does make sense about the vacuum... It would have to be measured from within the lifter galley and well, I know that isn't possible.  |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Performer RPM | -RootS- | Windsor Power | 4 | 04-25-2003 06:24 PM |
| Still Misfiring | MidNiteBlu 5.0 | Windsor Power | 17 | 12-02-2002 09:43 PM |
| Vacuum gauge.. | bobtodd | Windsor Power | 13 | 08-17-2002 02:07 PM |
| Vacuum Gauge | evilmustang | Windsor Power | 2 | 07-14-2001 08:10 AM |
| The benefits of a Vacuum Gauge!!! | PKRWUD | Windsor Power | 16 | 07-02-2001 09:12 PM |