Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-10-2002, 07:03 PM
|
#3 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
I just changed out the heads and didn't replace the oil. I don't see why you would need to. As long as you were careful about it and didn't let any of the coolant get into the engine you should be fine.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Will head/intake change, change sound of car? | FivepointOH | Windsor Power | 6 | 01-12-2004 12:26 PM |
| Intake Manifold Swap | 98gt5sp | Modular Madness | 1 | 09-03-2002 07:11 AM |
| Engine Swap & gear change | LABARINTH | Modular Madness | 1 | 03-12-2002 03:41 PM |
| 96 to 99 intake manifold swap? | T-Bone | Modular Madness | 2 | 05-13-2000 12:13 AM |