Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
12-20-2002, 11:36 PM
|
#1 |
|
Registered Member
Join Date: Dec 2002
Location: Philadelphia PA
Posts: 143
|
I am using 17 x 9 and they seem to fit nicely without sticking out too far. The top of the tire is almost flush at the sidewall with the fenderwell. I always get comments on how nice they look.
__________________
2000 GT 80mm Pro-M mass air, 24lb injectors, 75mm BBK T/B, K&N Filter Cold Air, 1/2" Phenolic intake spacer, Underdrive Pulleys, Dyno Tuned Autologic Chip, FMS Shorty Headers, Mac Prochamber 2 1/2" Off Road H pipe, 2 Chamber Flowmasters, Steeda lowering springs. Steeda Tri-Ax Short Throw shifter, Steeda Power slot rotors w/ Hawk Pro pads, 3.73 FRP Gears. Headwork and Comp cams install in progress. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Are all 8.8 rears the same? | 82 GT | Windsor Power | 29 | 08-23-2004 01:06 PM |
| 93 gt conv rear end question | sos | Windsor Power | 1 | 03-03-2004 10:11 PM |
| How to remove rear seat in 01' Mustang GT??????? | wickedgt | Modular Madness | 4 | 03-30-2002 11:40 AM |
| Rear end gears on 90 GT? | 00'BlackSteed | Windsor Power | 4 | 08-02-2001 12:57 PM |
| Rear seat delete for an '84 GT? | 84_GT350 | Windsor Power | 8 | 07-04-2001 06:41 PM |