

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#2 | |
Registered Member
Join Date: Dec 2002
Location: Philadelphia PA
Posts: 143
|
![]() Hey bro. Steeda makes a damn good setup for the mustang using the Paxton. Check it out at Steeda under the mustang category, then Fuel/Induction parts.
Quote:
__________________
2000 GT 80mm Pro-M mass air, 24lb injectors, 75mm BBK T/B, K&N Filter Cold Air, 1/2" Phenolic intake spacer, Underdrive Pulleys, Dyno Tuned Autologic Chip, FMS Shorty Headers, Mac Prochamber 2 1/2" Off Road H pipe, 2 Chamber Flowmasters, Steeda lowering springs. Steeda Tri-Ax Short Throw shifter, Steeda Power slot rotors w/ Hawk Pro pads, 3.73 FRP Gears. Headwork and Comp cams install in progress. |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
SN-92,SN-93,GSS Paxton Ball-Drive Guys Step INSIDE | Mustanguy | Windsor Power | 4 | 02-13-2006 12:13 PM |
ProCharger or Vortech? | PaxtonBlownStang | Stang Stories | 4 | 11-19-2003 12:15 PM |
Who will make more power..vortech-vs-Ati ProCharger | Paluka21 | Windsor Power | 13 | 07-16-2001 10:40 AM |
Paxton SC | StreetStang37 | Windsor Power | 7 | 06-18-2001 06:12 PM |