MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 07-04-2001, 09:02 PM   #1
Patrick Boetticher
Registered Member
 
Join Date: Feb 1999
Location: Camarillo/Thousand Oaks Ca
Posts: 223
Post

i still only have 19# injectors. the timing is set at a shockingly high 20* (my buddie woth the 351 and the same cam is at 24* so i saw if that would work...it works fine and no pinging...stock pump... umm at about 3500rpm it starts to miss a little bit, only when you keep it steady... umm... fuel psi is at 45psi no vaccume... where can i get a Probst book???? i am just tring to get ti to run good then ill mess w/it at the track... and the oil still is leaking from the bell housing cant find the stupid leak!!!

------------------
ALL NEW PPG Torch Red 95GT, 304ci block, Forged pistons, Ported Explorer Intake, E-303 cam, fully ported and polished and milled E-7 heads, 75mm MAS, BBK Adj. fuel Reg & gauge, BBK Shorty Headers, BBK H-pipe, March Pulleys, 2 Chamber Flowmasters, Kenny Brown 6 point Roll cage, Kenny Brown Panhard Bar, Powerslot Rotors, PBR twin piston calipers, Eibach Sportline Springs, 180* Thermostat, 1/2 Plenum Spacer, MSD 6AL, MSD Master Blaster, MSD 8.8 Wires, 24# Racing Injectors, AFS 10.5" Cobra R's, Nit
Patrick Boetticher is offline   Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:02 PM.


SEARCH