Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-05-2003, 10:44 PM
|
#4 |
|
Registered Member
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
|
Yeah, definetly something wrong. You should be running quicker with those heads and gears. Mine ran a 13.50 at 101.5 and i only had re worked stock heads, and get this: the stock 2:73 gears on the old 7.5 rear end. I have the Performer RPM intake with holley 600 carb. You should be hitting high to mid 12's. Could be pushrod length maybe not opening valves enough to make use of the heads?
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear. Production # 9,377 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| block and head machining questions | bmxmon | Windsor Power | 6 | 09-26-2004 02:21 PM |
| Head and intake flow. Something to think about. :) | 5ohCOUPE | Windsor Power | 3 | 03-16-2003 08:52 AM |
| How do compare heads and intake. | GodStang | Windsor Power | 4 | 02-01-2003 11:37 PM |
| Intake and head advice | taurus3298 | Windsor Power | 3 | 05-09-2001 06:55 PM |
| Head ID and Extrude-honed Upper intake | RSE1805 | Windsor Power | 1 | 03-23-2001 05:03 PM |