Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-05-2003, 11:21 PM
|
#6 |
|
cranky old man
Join Date: Sep 2001
Location: Longview Texas
Posts: 683
|
Well if your pistons are KB116's and you have 62 cc chambers and assuming a .039 gasket thickness and stock rods, my math says 10.07:1 not 10.7:1 but that still shouldn't affect you that much ?
I put some of your basic stuff in Desktop Dyno and it spits back 425 HP at 6000 RPM and 416 ft lbs at 4500 ... thats not by any means dead on to what you actually have of course but its close enough to tell me you should be faster than 13.80's I'm puzzled about you bogging coming out too ? Maybe you need to be a little more agressive on your launches? or maybe a lot more  Do you have any 60 foot times ? |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| block and head machining questions | bmxmon | Windsor Power | 6 | 09-26-2004 02:21 PM |
| Head and intake flow. Something to think about. :) | 5ohCOUPE | Windsor Power | 3 | 03-16-2003 08:52 AM |
| How do compare heads and intake. | GodStang | Windsor Power | 4 | 02-01-2003 11:37 PM |
| Intake and head advice | taurus3298 | Windsor Power | 3 | 05-09-2001 06:55 PM |
| Head ID and Extrude-honed Upper intake | RSE1805 | Windsor Power | 1 | 03-23-2001 05:03 PM |