Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
01-06-2003, 10:55 PM
|
#1 |
|
Guest
Posts: n/a
|
Low temp heat gun/hair dryer
Hi Jim,
Yes, it is possible to remove decals and onlay graphics with a low heat air gun or a low temp hair dryer; however, be prepared for fade. Especially on a colors like Red, Yellow and Blue, you may notice a distinct color difference in the paint and where the decals ran over the car. Go slow. If the decals/graphics are chipping due to UV damage, it will be a job. Patience is a virtue! Good Luck. ~Jenn~ |
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can you replace the middle part in your steering wheel without the airbag blowing up? | 96_4.6 | Blue Oval Lounge | 6 | 12-15-2002 12:12 AM |
| Attention Middle Tennessee People | ReefBlueCoupe | Blue Oval Lounge | 0 | 04-11-2002 11:25 PM |
| Middle Tennessee People, southern KY, northern AL read | ReefBlueCoupe | Blue Oval Lounge | 0 | 03-11-2002 11:38 AM |
| Bumper stickers | dinomite | Blue Oval Lounge | 27 | 05-15-2001 10:58 PM |