Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
01-11-2003, 12:37 PM
|
#1 |
|
Registered Member
Join Date: Sep 2002
Location: Boston
Posts: 592
|
Wouldnt it be much easier to just break off the supports that hold the clutch cable to the enginebay wall and change the geometry of the cable manually then ziptie it to something that will hold it away from the tubes?
This is what I did when it was touching the equal length mac's
__________________
91 GT Carb conversion, holley 600 double pumper, edelbrock performer intake, FMS "C" drop springs, march 1000 underdrive pullies, crane 1.7 roller rockers, GT-40P headers, bassani x pipe, american thunder catback, FMS 4.56's, msd aL6, trunkmount battery, A/C eliminator kit, 3000 stall tci streetfighter, AOD with transgo kit, A+ servo, 300M hardened lockup shaft, kevlar bands and 28,000 gvw trans cooler, 3 core radiator, 300 lbs stripped with a full interior |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Why can't I read the timing? | Bad89stang | Windsor Power | 10 | 10-31-2002 10:50 PM |
| yelowjaket -- READ this please | five.point.ohhh | Stang Stories | 2 | 09-20-2002 08:34 AM |
| T5 HELP, lining up tailshaft. Please READ! | LOBE_50 | Windsor Power | 2 | 12-29-2001 03:57 PM |