Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-15-2003, 02:16 AM
|
#5 |
|
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
I'm tired, so I'm going to bed, but i'll follow up this thread tomorrow. For now:
adjust the pump with the spring-loaded screw/bolt and nut that puts pressure on the pump arm. You want zero clearance, but you don't want ti to bottom our, either. Just make sure that even if a breeze hits the accelerator shaft, fuel squirts out of the squirter. The squirter is 1 phillips screw, and the cam is 1 flathead. Put it in the second hole. Good Night.  Before I forget, what is the List # of your carb (it's stamped into the airhorn)
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GM Engines | BLOCKER | Blue Oval Lounge | 2 | 04-13-2004 12:35 AM |
| Good valve springs for high RPM play | esandes | Modular Madness | 0 | 01-24-2003 04:50 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Vacuum reading at idle? | exgmguy | Windsor Power | 20 | 09-27-2002 06:22 AM |
| car still cuts out at high rpm | j's69stang | Classic Mustangs | 9 | 06-21-2001 10:23 AM |