Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-15-2003, 02:11 PM
|
#14 |
|
Registered Member
Join Date: Jan 2002
Location: Mt. Prospect,IL
Posts: 474
|
well guys, there was a kink, in the hose that goes to the heater core, the heater core was not even warm. afterdriving it from school. well push goes to shove after the kink was out and the water started to flow. instently i had heat coming out of the vents. I then checked the anitfreeze again and it was down an half of quart... So i learned another lesson, boy do i hate these dumb but not noticeable problems
thanks for all the help guys!
__________________
87-ford-mustang-SOLD! mods: 3:73's, off road h-pipe, b303 cam in gt- 40 motor w/ Power Plus intake, edelbrock 70mm tb & egr spacer, 72mm C&L, bbk long tubes, tremec tranny, centerforce dual friction clutch, upr and lwr CA's 255lph FP and soon more to come.... when i have money again SOME ADVICE Don't do burn outs in reverse it is very expensive New times with dead hook on dr's 13.27@103 with 2.0 60 foots w/100lb system Fastest time to date: 12.8@113 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bucking issue... | Girls can too | Windsor Power | 6 | 04-13-2001 02:25 PM |
| RUCA compatability issue? | 93notch | Corner Carvers Delight | 9 | 08-09-2000 12:31 PM |
| Which issue of MMFF | Dino | Modular Madness | 0 | 05-20-2000 06:10 AM |