LONGTUBES!!

Rick 91GT · 01-19-2001, 10:22 PM

I haven't had any problems burning clutch cables with my MAC 1-5/8", I had mine ceramic coated to make them last longer and look better. You do have to extend the o2 harness but I though every long tube had this issue

just buy the kit from Interactive Tech to extend them. If you have a Lakewood or other SFI approved bellhousing you will have to notch out the passenger side flange to fit the tube through, I didn't have to take my steering shaft out but I did have to unbolt both motor mounts to install them, all my smog stuff fit fine as well but since I am in a state that doesn't require emissions it's all off now

I would like to upgrade to the Bassani step headers 1-3/4"-1-5/8" they are really nice

but are expensive $400.00+

------------------
My Ride Check Out My Site 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60",Full MAC exhaust 1-5/8" Long tubes, 2-1/2" O.R H-Pipe, 2 1/2" cat back, 12" K&N Filter, RNH PERFORMANCE Ram Air, Ron Davis Radiator, Full Suspension,3:73's, Welds, Best on new motor-12.60 @ 108, no traction 1.98

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dr. Gas X-pipe - BBK longtubes???	429mustang	Blue Oval Lounge	8	03-07-2004 09:24 AM
Got the longtubes...now do I need 3" exhaust?	Stang_ROTY	Windsor Power	4	06-24-2003 07:04 PM
MAC longtubes 96-98 4v smoke screen	jax702	Modular Madness	0	05-20-2003 12:34 AM
Quick question on Longtubes...	89LXRagtop	Windsor Power	13	02-27-2003 11:31 PM
Shopping for longtubes..any suggestions?	HiFlow5 0	Windsor Power	15	06-17-2002 06:06 PM

01-19-2001, 10:22 PM	#3
Rick 91GT Procharged! Join Date: May 1999 Location: Hanover, PA Posts: 1,539	I haven't had any problems burning clutch cables with my MAC 1-5/8", I had mine ceramic coated to make them last longer and look better. You do have to extend the o2 harness but I though every long tube had this issue just buy the kit from Interactive Tech to extend them. If you have a Lakewood or other SFI approved bellhousing you will have to notch out the passenger side flange to fit the tube through, I didn't have to take my steering shaft out but I did have to unbolt both motor mounts to install them, all my smog stuff fit fine as well but since I am in a state that doesn't require emissions it's all off now I would like to upgrade to the Bassani step headers 1-3/4"-1-5/8" they are really nice but are expensive $400.00+ ------------------ My Ride Check Out My Site 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60",Full MAC exhaust 1-5/8" Long tubes, 2-1/2" O.R H-Pipe, 2 1/2" cat back, 12" K&N Filter, RNH PERFORMANCE Ram Air, Ron Davis Radiator, Full Suspension,3:73's, Welds, Best on new motor-12.60 @ 108, no traction 1.98