Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-17-2003, 06:34 AM
|
#6 |
|
Registered Member
Join Date: May 2001
Location: Harrisburg, Pennsylvania
Posts: 379
|
might be a leak in the intake gasket on the lifter valley side
i just tore mine down and discvered that my #3,4 and #8 cylinders were sucking oil in thruogh the lifter valley ,gasket didn't seal right.......i was kinda surprised that it could suck oil in through there ,but it was .......my #4 port was coated in oil and judging from looking at the gasket it looked like the others were drawling in some oil too
__________________
the "not so old",old guy 87 Mustang GT T-top >hanlon t-5, pro 5.0, centerforce clutch ,adj. cable/quatrant ,3.27s ,full 2 1/2 ex(off road H) adj. reg. ,e-cam ,70mm TB, cobra intake ,1.7rr ,ported/milled e7ets w/crane springs ,306 balaced/decked short block w/speed pro forged flat top pistons ...257rwhp/302rwt best et 13.7@102 (4/11 ) '80 Capri (future project,currently collecting parts for 351 moter) |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bad valve guide? | Hozer 88GTConv | Windsor Power | 6 | 01-23-2004 03:14 PM |
| valve problem | pearlgt40 306 | Windsor Power | 3 | 07-05-2003 01:21 AM |
| valve seal vs piston ring oil leak. | thdrcat | Classic Mustangs | 2 | 07-30-2002 07:06 PM |
| PCV Valve what the ?@#$@#$@$ | Chevyguy | Windsor Power | 3 | 04-11-2001 08:01 PM |
| Valve guide seals? | Shotgun28 | Windsor Power | 1 | 03-13-2001 11:48 PM |