Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-19-2003, 01:30 AM
|
#5 |
|
Registered Member
Join Date: Aug 2001
Location: Ft. Worth, TX
Posts: 456
|
valve cover gaskets
I can't believe nobody covered this yet but, avoid using cork gaskets when you get new ones. Get the rubber ones with the steel frame inside or just the rubber Fel-Pro gaskets. The cork gaskets tend to "sweat" oil after awhile and it makes everything nasty. REMEMBER: DO NOT TIGHTEN THE BOLTS DOWN MUCH! It only take a little pressure to seal them and too much will make them leak. Good luck, it's easy!
__________________
You're gonna need your seatbelt |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Is a valve cover breather bad for the 4.6???? | 96_4.6 | Modular Madness | 6 | 08-21-2003 06:38 PM |
| valve cover gaskets? which ones? | Coupe50h | Windsor Power | 5 | 03-05-2003 09:52 AM |
| Changed valve cover gaskets what fun | Chevyguy | Windsor Power | 2 | 09-05-2001 01:52 PM |
| A Valve Cover Story (long but gimme some pointers here) | Super_Stang | Windsor Power | 1 | 08-12-2001 07:29 AM |
| Valve Cover leaks...help!! | quick89gt | Windsor Power | 3 | 01-21-2001 09:54 PM |