Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
07-11-2001, 04:35 PM
|
#1 |
|
Registered Member
Join Date: Jan 1999
Posts: 126
|
My edelbrock heads needed nothing you can reuse your rockers and pushrods I opted to get roller rockers and bought new pushrods cause there cheap and its just cheap insurance that your not putting in a bent one.
------------------ 93 coupe,373's ripper shifter,MAC 1-5/8 equal lengths,MAC 2-1/2" H-pipe with cats,flowmaster 2 chambers,lowered 1-1/2" with BBK springs.Motorsport HD clutch,,FMS pullies,75mm bullet maf,walbro 190 lph fuel pump,kirban adj fpr.edelbrock 6037's e303, cobra intake frpp 1.6 roller rockers mac cold air kit msd 6al 3" cowl hood factory five upper and lower control arms wms subframe connecter and strut tower brace 12.81@ 105.1 1.66 60ft |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GT-40X heads ? | Mustang_289 | Windsor Power | 9 | 09-30-2003 08:21 AM |
| New Heads. Any Tips | 66StangGuy | Classic Mustangs | 5 | 09-15-2003 08:20 PM |
| question on EDEL heads ...6022 | vande97 | Windsor Power | 3 | 02-16-2002 03:19 PM |
| Heads and Cam....tough question | cyberstang5.0 | Windsor Power | 2 | 12-07-2001 09:22 AM |
| A general question about heads! | Thad | Windsor Power | 0 | 10-10-2001 11:17 AM |