Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-26-2003, 12:20 PM
|
#6 |
|
Registered Member
Join Date: Dec 2002
Location: Ontario Canada
Posts: 91
|
umm, i really dont have any other ideas. have you priced out a going to wide ratio gear set, cause if so, you could always, just get that, then have the tranny rebuilt, maybe buy a manual valve body, and upgrade the input shaft on it, its really hard to say, all i can say is go around to shops that rebuild them and see what they can tell ya.
later
__________________
87 GT T-roof (needs paint) lol, rebuilt motor and trans, AOD - stage 2 shift kit, 3.73 gears - auburn posi, Dynomax Super Turbo Cat Back, FRPP 155lph fuel pump, K&N filter - air silencer removed, subframe connectors, strut tower brace. 88 GT T-roof 1989 LX Coupe 5.0 - 5spd Rice Haters Club member#105 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| where to get a burned chip??? | pedley | Windsor Power | 3 | 08-02-2003 03:31 PM |
| Custom Burned Chips | XTheOwl | Modular Madness | 2 | 06-03-2003 05:00 PM |
| Burned Wire | VeNuM | Windsor Power | 2 | 02-23-2003 08:12 PM |
| Burned hand no more electric | Just me | Windsor Power | 6 | 05-08-2002 01:51 AM |
| Any where in Texas to get a new Prom chip burned | n20neenee | Windsor Power | 2 | 01-09-2001 07:40 AM |