Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-03-2003, 03:26 PM
|
#5 |
|
Registered Member
Join Date: Dec 2002
Location: Philadelphia PA
Posts: 143
|
That dtc is for the oil pressure switch. It almost always shows up. If that was the only code you got, then go ahead with resetting the computer by disconnecting the battery terminal. This should clear the check engine light. If it comes back on, then you may need to take it to the dealership for further troubleshooting
__________________
2000 GT 80mm Pro-M mass air, 24lb injectors, 75mm BBK T/B, K&N Filter Cold Air, 1/2" Phenolic intake spacer, Underdrive Pulleys, Dyno Tuned Autologic Chip, FMS Shorty Headers, Mac Prochamber 2 1/2" Off Road H pipe, 2 Chamber Flowmasters, Steeda lowering springs. Steeda Tri-Ax Short Throw shifter, Steeda Power slot rotors w/ Hawk Pro pads, 3.73 FRP Gears. Headwork and Comp cams install in progress. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| check engine light | bubbalink | Windsor Power | 3 | 07-30-2004 03:44 PM |
| Check engine light on a 2000 GT | GITY UUP | Modular Madness | 11 | 04-30-2002 10:16 AM |
| New Guy w/ Check Engine light? | Stang_ROTY | Modular Madness | 7 | 06-18-2001 11:34 AM |
| Turning Off "Check Engine" Light | King Snake | Modular Madness | 3 | 04-01-2001 07:18 PM |
| Check Engine Light? | Maxi 5.0 | Windsor Power | 3 | 01-09-2001 10:50 PM |