Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
02-10-2003, 09:41 AM
|
#1 |
|
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
The cable that is closest to the drivers side is your throttle cable, and you already have it removed.
The other cable is called the Throttle Valve(TV) and you must NOT adjust this cable because you will most likely fry your AOD if it is mis-adjusted. Don't try adjusting it to get firmer shifts. It will pop out of the grommet with just a little force from a flathead screwdriver. Then your new TB should already have the rubber grommet in place. Just pop it in the new one and you're all set.
__________________
NMRA O/C 9516 NA pumpgas stickshift 347 10.65@125.6, 6.73@100, 1.41 60ft |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tranny kickdown cable | Midnite Wrider | Classic Mustangs | 16 | 05-03-2005 10:20 PM |
| Clutch Cable w/ Long Tubes | GhOsT6_9 | Windsor Power | 1 | 05-14-2004 07:53 PM |
| No tension on clutch cable... what am I missing? | Bad89stang | Windsor Power | 6 | 12-22-2003 07:59 PM |
| throttle cable | jfharris | Windsor Power | 2 | 12-13-2003 10:39 PM |
| Cobra Throttle Body on a LX?????? | Stang Runner | Windsor Power | 2 | 06-24-2001 06:19 PM |