Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-11-2003, 11:53 AM
|
#4 |
|
or '331 LX Eric'
Join Date: Jan 1999
Location: Columbus, Ohio
Posts: 2,142
|
Yeah, you'll need to either break the welds on your old crossmember or buy the adjustable one from Ford. I purchased the adjustable one, then put two small spot welds to hold it where it needed to be. Very simple thing to do.
As for sensors, the Tremec will have them in place, you just need to re-connect the plugs/wires onto the new sensors. Hope this helps, E
__________________
1991 5.0 LX Coupe - 40,750 miles 331 cu. in. / Tremec 3550 / BFG Drag Radials 12.22 @ 114.31 mph - w/1.89 60' |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cobra Engine Swap...Ways to improve my 98 GT... | xtrememach1racer | Modular Madness | 3 | 10-31-2002 11:23 AM |
| Rearend swap | H'YAMULE | Classic Mustangs | 0 | 02-19-2001 09:48 AM |
| 2.3 turbo swap | frankiebonzz | Small Ponies | 0 | 06-01-2000 07:44 PM |
| tremec 3550 swap | 97 Aztec | Modular Madness | 2 | 12-03-1999 09:12 PM |
| more turbo swap questions | Trevor | Small Ponies | 7 | 08-29-1999 05:45 PM |