Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-15-2003, 07:56 AM
|
#3 |
|
Registered Member
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
|
yeah, just put a bolt in each hole. same size as the matching holes in front of the head(where accesories bolt up). thats why the heads are interchangable, left and right cause the hole goes all the way thru and is tapped the same on both ends.
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear. Production # 9,377 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tranny filler tube? | mystang_71 | Classic Mustangs | 2 | 07-10-2003 03:25 PM |
| Heater water supply and return tube | Cody2552 | Windsor Power | 3 | 03-24-2003 11:34 PM |
| Bullit Intake Aftercooled Discharge Tube | SlwGT | Modular Madness | 0 | 06-10-2002 08:27 PM |
| I want to remove my EGR tube | moponys | Windsor Power | 0 | 12-04-2001 10:54 AM |
| CARB. v/s INJECTION!! EVERYONE MUST READ THIS! | 5.0-man | Windsor Power | 2 | 03-17-2001 11:12 AM |