Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
02-15-2003, 12:26 PM
|
#1 |
|
Registered Member
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
|
well, I am looking at the new holley heads on my engine stand and the holes for the air intake are the same as the front ones for the accessories. the driver side head has smaller holes for everything else though. but if you swap them the other head comes out the same. there is no left and right head as far as i know, but your friends heads might have inserts in them to make em work with his accessories? I have a pair of 351 heads in my shed i will look at. I know they have bolts blocking the air intakes also.
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear. Production # 9,377 |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tranny filler tube? | mystang_71 | Classic Mustangs | 2 | 07-10-2003 03:25 PM |
| Heater water supply and return tube | Cody2552 | Windsor Power | 3 | 03-24-2003 11:34 PM |
| Bullit Intake Aftercooled Discharge Tube | SlwGT | Modular Madness | 0 | 06-10-2002 08:27 PM |
| I want to remove my EGR tube | moponys | Windsor Power | 0 | 12-04-2001 10:54 AM |
| CARB. v/s INJECTION!! EVERYONE MUST READ THIS! | 5.0-man | Windsor Power | 2 | 03-17-2001 11:12 AM |