Threaded Mode
© Copyright 2026 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-20-2003, 11:41 AM
|
#2 |
|
347ci of HORSE POWER!!!
Join Date: Jul 2001
Location: Houston, TX
Posts: 1,416
|
If your going to drive it on the street a lot, then I would go with the 3.73's. That is what I have in my stang. I installed them myself as well. It wasn't that hard. I took my time to make sure I got the tooth pattern the way I wanted it. I think at 75-80mph, you'll run about 2.3-2.5K RPM. Expect about a 2 mpg gas drop. That's not a lot compared to the amount of pull you get.
 I have no clue what my top end is, but I got mine up to 130mph and I was only sitting at 4K rpm. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Quick questions on Explorer Intake install. | Falcons Talon | Windsor Power | 2 | 08-21-2003 12:40 PM |
| Roller Rockers for my AFR's.....and install questions | dragstang86 | Windsor Power | 4 | 12-31-2002 08:18 PM |
| AdjustTiming & 3.73 Gears install | Blue01GT | Modular Madness | 2 | 03-20-2002 02:46 PM |
| Roller Rocker install questions. (long) | chris91LX | Windsor Power | 5 | 03-15-2001 09:32 PM |
| FMS A/C elim install questions | sedanman | Windsor Power | 5 | 01-30-2001 03:25 PM |