Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-20-2003, 01:09 PM
|
#2 |
|
Registered Member
Join Date: Sep 2002
Location: NYC
Posts: 245
|
The tilt in-out adjustment is ontroled by the front and rear runs. They are the curved metal rods that screw into the base and top of the door. Pulling the bottom in pushes the top of the window out. Pushing the run to the outside of the door, tilts the window back in.
__________________
1970 Stang Conv: en:Boss351 (balanced/blueprinted) mech cam(240*@.050/.540 lift) Scrw in studs/comp cams rllr rkr Mldn valves 2.19in 1.71ex ported polished cc'd hrdnd ex Keith Black FT pistons(10.25/1) Weiand Excellorator manifold Holley700 DP mech 2nds MSD 6 box and Dis Headers/2 1/2 inch duels tr: modified FMX re:9-inch/3.89 limited slip |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Self Adjusting Clutch Mechanism | oil99 | Built Ford Tough | 1 | 03-03-2004 08:09 PM |
| Help adjusting coil overs | ciara | Windsor Power | 3 | 01-26-2004 03:31 AM |
| adjusting valves/ stud mount?? PKRWUD? Anyone?? | Simi Stang | Windsor Power | 8 | 07-08-2003 11:43 AM |
| Problems adjusting Fuel Pressure | Rebel79 | Windsor Power | 13 | 09-28-2001 12:54 PM |
| Adjusting Crane 1.7 Roller Rockers | withamc | Windsor Power | 2 | 02-03-2001 07:04 PM |