Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-05-2003, 10:00 AM
|
#20 |
|
Registered Member
Join Date: Jul 2002
Location: Oklahoma City
Posts: 208
|
Regards headers, JBA shorties did not fit my '65. They collided with the steering gear and the output on the left side was aimed directly at the clutch z-bar equalizer. They just didn't fit. Note that the headers seen in your picture look hammer banged to make them clear the steering gear. They may work okay in the following situations: no power steering, rack and pinion steering installed and cable clutch linkage or automatic trans. Otherwise I'd steer clear of bargain headers. The likely reason they're for sale is they didn't fit properly.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| speedy density to mass air questions | thdrcat | Windsor Power | 3 | 09-25-2003 09:20 PM |
| Analog Radios, Kick Panel speakers, Installation and coloring questions | bigbandjohn | Classic Mustangs | 0 | 01-19-2003 12:51 PM |
| Gathering info on roll cage installation. | Fox Body | Windsor Power | 5 | 02-25-2002 11:35 PM |
| Rookie Questions on Gauge Installation | RED92LX50 | Windsor Power | 3 | 07-20-2001 10:18 AM |
| S-Trim Installation Questions?? | quick89gt | Windsor Power | 2 | 04-07-2001 10:02 AM |