Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-17-2001, 08:37 AM
|
#4 |
|
Moderator
Join Date: Mar 2001
Location: Myrtle Beach SC
Posts: 1,643
|
Saleengts: is that kit for a carb. I dont want to run EFI. I want a clean looking engine bay that I can work on. I can't work on an EFI system. I already have a e-303 cam but can get a new if it will be better for that combo.
------------------ '93 lx 4 banger, wrecked '90 lx 5.0, w/ t-5. .030 over fully ported and polihed (did that just to see if I could-first attempt at it). Motor and tranny in use for Ranger project. Cocked, locked and ready to rock Pony Power Forever |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Edelbrock heads | Scrapla | Windsor Power | 4 | 03-28-2004 08:39 AM |
| Edelbrock Heads - Finally Installed | NO SLO PK | Windsor Power | 6 | 07-29-2003 11:14 PM |
| 4.6 DOHC Head porting | Nitrous Al | Modular Madness | 7 | 03-15-2003 11:23 PM |
| Edelbrock Heads Install - Half way there!! | NO SLO PK | Windsor Power | 3 | 12-24-2001 11:43 AM |
| edelbrock performer rpm heads | hippi97 | Windsor Power | 2 | 04-01-2001 08:40 PM |