Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-18-2001, 11:15 AM
|
#7 |
|
Moderator
Join Date: Mar 2001
Location: Myrtle Beach SC
Posts: 1,643
|
I found this on the internet It state:
A 89 Ford Ranger with a 302, Edelbrock heads and intake, Trickflow cam, five speed, 8.8 rearend with 3.73 gears, 26X10 mt slicks, 3540 pounds with driver ran an 12.856 @104.56 in the quarter. It said the truck had clutch problems (engagement). Since I don't know if I will still get a Ranger or Mustang (read I'm pissed in the Blue oval) Which would run faster the Ranger or Mustang setup exactly the same? ------------------ '93 lx 4 banger, wrecked '90 lx 5.0, w/ t-5. .030 over fully ported and polihed (did that just to see if I could-first attempt at it). Motor and tranny in use for Ranger project. Cocked, locked and ready to rock Pony Power Forever |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Edelbrock heads | Scrapla | Windsor Power | 4 | 03-28-2004 08:39 AM |
| Edelbrock Heads - Finally Installed | NO SLO PK | Windsor Power | 6 | 07-29-2003 11:14 PM |
| 4.6 DOHC Head porting | Nitrous Al | Modular Madness | 7 | 03-15-2003 11:23 PM |
| Edelbrock Heads Install - Half way there!! | NO SLO PK | Windsor Power | 3 | 12-24-2001 11:43 AM |
| edelbrock performer rpm heads | hippi97 | Windsor Power | 2 | 04-01-2001 08:40 PM |