Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-13-2003, 06:37 PM
|
#4 |
|
Registered Member
Join Date: Feb 2002
Location: Birmingham, Al
Posts: 65
|
I really was not worried about it tipping as much as I am about these 4 little bolts holding.I also was worried as the stand had no actual brand name and I am learning the hard way that you get what you pay for.I bought some 3 inch bolts at auto zone to attatch the motor to stand and I think they are just standard bolts.I am wondering if there are some special ultra strong bolts or something I need.This motor is going to be taken apart by me just to learn the basics so it is really just a spare motor.I may order a quality stand for my 331 replacement.Any ideas if one stand is better than another or am I just worried for nothing?
__________________
1992 G.T. oxford white |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rare Mustangs....Got One? | 1969Mach1 | Blue Oval Lounge | 22 | 09-25-2010 04:59 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Classic Mustangs | 8 | 06-16-2005 11:43 AM |
| Bolts for engine to engine stand?? | DemonGT | Windsor Power | 8 | 04-15-2003 10:16 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Small Ponies | 0 | 05-12-1999 02:27 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Racer's Club House | 0 | 05-12-1999 02:27 AM |