Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-25-2003, 10:50 PM
|
#1 |
|
Registered Member
Join Date: May 2002
Location: Chapel Hill, NC - USA
Posts: 188
|
i'm guessing about getting the knob tight between the knob and the supplied nut... if not then please elaborate.. but if i was right, then just get one of the rubber jar opener things and hold the knob in place with one hand. with the other use a wrench and tighten the nut to go up TO the knob, its supposed to go against each other.
also, if your nut is like mine then one part is cylindrical and protrudes from the nut part... that part goes up against the ball.... Torinalth
__________________
When you finally shut down the car, just sit back and remember the run.... win or lose, you know it was a surge of adreneline |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Door Handle Replacement | Dan_Cicero | Small Ponies | 1 | 05-28-2003 03:57 PM |
| Another "How to" question... | got5.0? | Windsor Power | 3 | 12-15-2002 07:15 PM |
| hurst shifter question | jjmel | Modular Madness | 6 | 07-14-2002 10:18 AM |
| Door handle help | HellRaiser92 | Blue Oval Lounge | 1 | 04-20-2002 04:03 PM |
| will steeda tri-ax handle fit on my hurst short throw shifter? | SHaFT7 | Windsor Power | 1 | 06-10-2001 03:10 PM |