Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-27-2003, 04:29 PM
|
#2 |
|
Registered Member
Join Date: Feb 2002
Location: Virginia
Posts: 11
|
Bought a C&L 80mm maf and intake tube and all my car does is try to stall and once i drive it dies.....I bought it used and i cant tell the air sample tubes apart could that be the problem i.e i have a 24lb injector sample tube for the maf in and i only have 19?? Any help would be great, thanks
-------------------------------------------------------- The mass air meter needs to calibrated for use with whatever size injectors you decide to use. You can also find out some information here about the calibration process. http://www.pro-flow.com/tech%20info/calprocess.htm I also found some good information at this site regarding the C&L meters. http://www.supercoupeperformance.com/C&L%20Pics.htm Hope this helps. Vince
__________________
1993 Mustang GT ------------------------------ Mods: 80mm Pro-m mass air, 75mm Accufab TB, 36lb Bosch injectors, 255lph in tank fuel pump, Anderson power pipe, Kirban AFPR, Autologic chip, Powerdyne 9lb supercharger, Centerforce dual friction clutch, 3.73's, Dynomax superturbo mufflers, no cats, Mac shortys unequal length headers, B&M ripper shifter. MAC upper and lowers. ------------------------------------------ 301.0 RWHP 350.3 ft/lbs torque ------------------------------------------ Vince |
|
|
|
|