Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-21-2001, 07:37 PM
|
#3 |
|
Registered Member
Join Date: Oct 1999
Location: Gordonville MO USA
Posts: 448
|
check out www.worldcastings.com to see their
new Rousch-tweaked iron Windsors. Should be right up there with AFR's, TF's etc per a dyno article I have, and I think they can be had for around $800. If that's too much, your next bet (if you can't find a good used set of some kind?) would be the GT40P explorer iron heads - they can be had quite reasonably - look in Mustang/Ford mags. The one thing they lack is a decent sized exhaust valve (1.45) but you could maybe get the 1.54's put in. They take a specific header to clear the diff angle on the plugs though. Maybe GT40's? |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Price estimate for barely used Edel. Perf. RPM alum. heads w/ 2.02/1.60 valves?? | Simi Stang | Windsor Power | 13 | 11-03-2003 11:23 PM |
| Cleveland vs. 302 | MetalHead | Stang Stories | 1 | 03-06-2002 01:48 AM |
| Pure Street legal heads | Nitrous Al | Windsor Power | 7 | 01-21-2002 08:40 AM |
| For whoever it was considering using stock ported heads | 2FastLX | Windsor Power | 5 | 10-11-2001 01:53 PM |
| TFS street or track heat heads?? | DemonGT | Windsor Power | 7 | 08-17-2001 12:13 AM |