

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#2 |
Registered Member
Join Date: May 1999
Location: Hialeah,Fl,USA
Posts: 57
|
![]() your clutch may be gone already,check the fork it may bent or worn finger that hold throw out brg. I had the same problem before, my clutch burnt up in 8 months because i kept adjusted the cable due to clutch was hard to engaged,very hard pedal.I took out everything all the way to the flywheel.I resurface flywheel,installed new king cobra clutch,replace the fork (the old one worn pretty bad),change stud ball on the inside of bell housing too you should change this when you change the fork because both of them wear down the same time and bamm!!! all problems were gone.Hope this help
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Throwout Bearing Blues | Rstng93 | Blue Oval Lounge | 2 | 06-19-2004 07:41 PM |
clutch and throwout bearing questions | bmxmon | Classic Mustangs | 0 | 05-23-2004 04:32 PM |
T5 throwout bearing chirp..Argh | squid | Windsor Power | 1 | 09-20-2002 08:37 PM |
Need advice on throwout bearing | RPM427 | Windsor Power | 2 | 08-28-2002 02:05 PM |
throwout bearing noise!! | Coupe5oh | Windsor Power | 1 | 04-30-2002 05:38 PM |