Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
04-22-2003, 05:23 PM
|
#1 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
I am not sure of the company, but they do sell a bit, that you install in place of one of your valves, and put the other end in the chuck of a drill, and install the heads. It is the same size as the valves you are using and makes a perfect notch, as long as you don't cut too much. I saw it in one of the MM&FF articles.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Notch goes 3 and 0 | tireburner163 | Stang Stories | 7 | 04-28-2004 09:14 PM |
| Largest cam in 351W without cutting the pistons (Looking at AFR185s) | Fox Body | Windsor Power | 10 | 06-15-2003 12:39 AM |
| Pistons for Larger Valves? | MustangChile | Classic Mustangs | 4 | 02-28-2003 01:27 AM |
| Rear Speaker options for 90 LX Notch??? | Chevyguy | Audio, Security, & Electronics | 3 | 11-01-2001 07:50 PM |
| Notch wasn't so mighty! | Try Me | Stang Stories | 5 | 03-26-2001 04:08 PM |