HOW LOW CAN I GO

[aaa]

Originally posted by MiracleMax:
You could if you wanted to go like 15 miles per hour in overdrive at redline!

Seriously, as an example going from a 2.73 to a 3.73, may car lost 9 mph on the top end (went from 135 to 126 mph) so any torque advantage you might realize from going to such a steep gear would be traded off on the top end. If your mill is stock with stock
electronics, it starts going south powerwise above 5500 rpm and then you bump into the rev limiter at 6250! This is all considering tires in the 24 to 26 inch range, if you plan on running a set of 44 inch super diggers in the rear then you might be able to run those 4.88's

SO WHAT DO YOU THINK A GOOD GEAR WOULD BE?? 4:11s IT IS AOD. AND WHAT ABOUT THE ALUMINUM
DRIVE SHAFT?