Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-28-2003, 12:21 PM
|
#15 |
|
Registered Member
Join Date: Jan 2003
Posts: 66
|
I assume you are using a breaker bar? It's best to remove it while its bolted up to the tranny but you should be able to get it if you use a quick, (obviously)counter-clockwise turn on it. Almost like pulling the tablecloth out from under the dining ware. If you go slow you'll just turn the crank.
__________________
66 coupe: 351W 30 over. Fiberglass shelby parts + flares |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pully install problem | CaliJ1 | Modular Madness | 14 | 07-31-2003 12:34 AM |
| alternator pulley to crank pully ratio | redrider | Windsor Power | 0 | 12-18-2002 11:43 AM |
| March ram air and pully kit | 91PA5liter | Windsor Power | 4 | 06-03-2002 07:35 PM |
| Steeda pully install = oil leak?!! | Rally | Modular Madness | 7 | 04-05-2002 02:58 PM |
| pully sizes 5.0 | greydan | Windsor Power | 3 | 12-14-2001 01:27 AM |