Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-05-2003, 11:55 AM
|
#3 |
|
Registered Member
Join Date: Jul 2001
Location: Reed City Mi
Posts: 106
|
What I used was a Mcloud scatterproof bellhousing, tremec tko, aluminum driveshaft with the correct spline. But I am a little curious on the shift fork. I used the stock one and it seems to make the pedal a little more stiff at the end of the travel. I thought this was the shift fork that I was suppose to use. Is there another one?
__________________
'94 GT, 347 stroker, AFR 185's, Trick Flow stage 2 Cam, Edelbrock upper and lower, 70mm Tbody, 77mm MAF, 24lb injectors, 255 lph pump, underdrive pulleys, 1 5/8 Motorsport Headers, king cobra clutch, tremec tko, 3.73 gears, flowmasters Last edited by jruppert; 05-05-2003 at 02:28 PM.. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Which Tremec since T5 bit it? | Mad Horse | Windsor Power | 14 | 10-14-2004 09:47 PM |
| Truth about Tremec | rancheroo | Windsor Power | 17 | 02-07-2004 03:15 PM |
| Bellhousing clutch pivot setup...? | drudis | Windsor Power | 4 | 01-23-2004 08:13 PM |
| Tremec 3550, aluminum fly & clutch INSTALLED! | 302 LX Eric | Windsor Power | 3 | 10-01-2001 04:05 PM |
| Longtubes w a Tremec 3550? | fastang | Windsor Power | 2 | 03-15-2001 07:43 PM |