white face's how to

[Ackbar00]

Its pretty straight forward. I got the El-Glo's on mine. Took about 2 hours. Disassambe the dash. Cant be more specfic about it, just look for anything that is attach and remove it. Remove the Hazards and light switchs, the un plug from the back. Once you have a clear shot at the cluster, take all the screws out holding it. pull it out slowly and reach around on each side and pull out the wire harness. To remove the speddo cable, I think you have to twist and push in than pull out. Once you have the cluster out, take off the clear plastic peice. You should now have firect acces to the needles on the guages. Either take a digital pic of where the needles are pointing or draw yourself a diagram. With the supplied tool, gently pull the needles up and off. If your Elglos are like mine, you just lay them over the top of the factorys faces. Put the needles back on acording to what the pic you took looks like. Reverse this whole process to put back in.

As for the wiring, Tie the power into the headlight switch (Use a test light to find out witch wire to butt into). Find a grond somewhere and then mount the controler somewhere. Mine is attached to a existing screw by the door.

Hope this helps.