Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-21-2003, 11:34 PM
|
#2 |
|
Registered Member
Join Date: Jul 2002
Location: San Clemente CA.
Posts: 85
|
Well this is kinda a bummer. I gt it all sorted out, minus the Kickdown, and fired it up. Runs a lot better than my old Aotolite 2 barrel, but the Idle is a bit high. after running up the street a bit I noticed that my Vac gage is reading onl at 5psi. It normally runs at 20. Hmm, now what could that hissing noise under the hood be? pull back in the garage and pop the hood.... well the rear end cap gave out and was bleeding oil ALL OVER the tranny and engine, as well as droping Vacume. the wife is tired of me working out there tonight so It will have to wait untill tomorrow after work before I can fix it.
Darn it, Ive been looking forward to running this car and now I have to wait again... Oh well. Mike
__________________
A great man once told me, "..." Well any way I guess that he wasn't that great. My garage: 1971 Mustang Grande, MSD6A, 625 Road Demon JR, Edelbrock Performer manifold, Hopes and Dreams... 1970 Norton 750 Commando 1993 Saturn SC2. The wifeys. fuzzy dice and all. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| intake manifold cracked on my 97 GT-help! | jinx6570 | Modular Madness | 4 | 12-23-2002 03:28 AM |
| Intake Manifold Swap | 98gt5sp | Modular Madness | 1 | 09-03-2002 07:11 AM |
| 2 aftermarket intake manifold questions | 84LX89GT | Windsor Power | 11 | 02-21-2002 07:36 PM |
| Check this out: prototype 5.0 intake manifold??? | Dark_5.0 | Windsor Power | 2 | 02-17-2002 10:50 AM |
| intake manifold selection | yusuf | Windsor Power | 0 | 03-05-2001 04:07 AM |