Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-22-2003, 08:38 AM
|
#5 |
|
Registered Member
Join Date: Oct 1998
Location: Dayton, OH USA
Posts: 678
|
Rev, thanks for the suggestions. But what is a windage tray and a crank scrapper? Yes, the engine was rebuilt about 10,000 miles ago at a local performance shop. They said I would get around 260-270 HP out of it, I guess they overestimated a little! I'm not sure about the compression, I've never done a compression test.
So you like the TFTW or APR heads better than the GT40s? Was hoping to pick up a set of GT40 (either cast or aluminum) for it. Thanks Harry |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 331 Dyno results | 302 LX Eric | Windsor Power | 12 | 04-29-2004 10:13 PM |
| PKRWUD: Fuel Pressue Test Results ?? | 95mustanggt | Windsor Power | 8 | 07-17-2002 01:11 AM |
| you will NOT believe this... dyno results | fiveohpatrol | Windsor Power | 27 | 11-27-2001 02:53 PM |
| Dyno results inside with timing adjuster installed | Mustang92 | Modular Madness | 7 | 02-20-2001 09:24 PM |