Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-26-2003, 03:59 AM
|
#12 |
|
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
10 degrees advanced is always a good place to start.
BTW, if you ever do swap in a T5, and the ECM, make sure you clip the wire going to pin 30 on the ECM. Your auto has a voltage carrying wire that the manuals don't, and it will fry the manual ECM. Also, I don't remember, but I thought the auto Mustangs had a PSPS (power steering pressure switch) that bumped the idle speed when it detected pressure from the p/s pump. If it does, yours is probably bad. Take care, ~Chris
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| raced a Supra Twin Turbo | Stang35th | Stang Stories | 63 | 08-23-2003 12:36 AM |
| The Right Speedo Gear... | Titan | Modular Madness | 8 | 09-23-2002 05:42 PM |
| Recommendations on a rear gear ratio | jim_howard_pdx | Windsor Power | 1 | 09-15-2002 12:10 AM |
| speedo gear | redrider | Windsor Power | 1 | 01-17-2002 10:06 PM |
| new gear ratios | faststang90 | Windsor Power | 2 | 12-27-2001 03:29 AM |